Share Experience for Porsche PIWIS Tester 2 V15.1VCI Configuration Error

Sometimes when your piwis tester ii connect USB and Power indicators turned on, the Porsche PIWIS VCI displayed an error message: “VCI configuration error. There is no VCI was recognized.”




We have few customer feedback that the Porsche PIWIS Tester 2 V15.1 VCI may meet configuration error when the piwis tester ii have well communicated has been built with laptop. technician check the problem and share experience for Porsche PIWIS Tester 2 V15.1VCI configuration error.

Possible reason:
Incorrect operation. Porsche tester II users do not need to enter into VCI self-test procedure.

Please follow the correct operation procedure provided below:
1) Turn ignition to ON and start the engine
2)Connect Porsche Tester II system to the car, wait until the indicator light flashes then connect the device with computer using USB cable.
3)Select your Porsche model and year


4)Enter PIWIS diagnostics interface.


5) If the system displays “Control unit selection: Loading control unit selection”, the PIWIS software is working.


NOTE: you won’t see control unit list if piwis tester is not connected properly or the device is damaged.

6) If the system cannot detect vehicle ECU modules, there is no good communication among the vehicle,device and computer or the tool is damaged.


This entry was posted in Uncategorized. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *